Acme Revival is an independent repair network that operates separately from the manufacturers whose devices we service. Our independence enables a repair model that exists beyond manufacturer-controlled strategies, while preserving the ability to work with manufacturers where appropriate.
Check Point Software Technologies is an Israeli cybersecurity OEM and software company best known for enterprise network-security gateways and firewalls. Its hardware portfolio includes network security appliances/gateways used to protect corporate networks, data centers, branch offices, cloud-connected environments, and industrial/OT networks. These appliances are combined with Check Point's security software, threat-prevention subscriptions, centralized security management, endpoint/mobile protection, and cloud-security products. Network Security Gateways remain its principal hardware product category, while a substantial portion of the company's overall business now comes from recurring security subscriptions, software updates, and maintenance.
Internal SSDs or hard drives can fail or disappear from the system, producing boot problems, I/O errors, or a DEGRADED/MISSING RAID state. Check Point provides hot-swap and RAID1 recovery procedures across numerous appliance families specifically for failed storage devices.
AC or DC power-supply modules can fail, causing PSU alarms, amber/red status LEDs, unexpected shutdowns, or complete loss of power on single-PSU models. Higher-end Check Point appliances commonly use redundant hot-swappable PSUs so operation can continue after one supply fails.
Chassis cooling fans can stop, slow below their permitted RPM range, or become mechanically noisy as their bearings deteriorate. Check Point hardware monitoring explicitly reports individual fan state and RPM and identifies a failed fan with a hardware.fan.state failure condition.
Blocked airflow, failed fans, dust buildup, or cooling-system degradation can cause internal temperature sensors to exceed their permitted thresholds. Affected appliances may generate hardware alerts, become unstable, throttle, or shut down to protect internal components.
The primary BIOS can become unusable, causing supported appliances to start from their secondary or recovery BIOS instead. Check Point specifically documents this condition as a primary-BIOS failure and certain enterprise models require appliance RMA when the documented failure criteria are met.
Dual-drive Check Point appliances can enter a DEGRADED RAID state when one storage device is missing, failed, or unable to synchronize correctly. The appliance may remain operational on the surviving disk, but redundancy is lost until the defective drive is replaced and the RAID mirror successfully rebuilds.
Onboard Ethernet interfaces and replaceable expansion line cards can develop failed ports, intermittent links, inability to negotiate a connection, or complete interface loss. Depending on the appliance family, the fault can originate in the physical connector, PHY/interface circuitry, expansion card, or its motherboard connection.
Motherboard voltage rails or associated power-regulation circuitry can drift outside their acceptable operating range or fail completely. Check Point's Hardware Health system continuously monitors internal voltage sensors because abnormal rails can produce boot failures, spontaneous resets, instability, or complete appliance failure.
DIMMs can develop memory errors or fail to initialize reliably, resulting in boot problems, crashes, unexplained reboots, or general system instability. System memory is a replaceable hardware component on multiple enterprise Check Point appliance families, with persistent hardware-level memory faults typically requiring DIMM or appliance replacement.
Connect with a technician.
Orders can typically be cancelled 24 hours prior to shipping
Get a real-time offer. Enter the make and model to begin.
Acme offers several ways to pay your service or repair balance.
Securely powered by 
This service is provided by Community Federal Savings Bank (“CFSB”), member FDIC, for which GoCardless Ltd acts as a third-party servicer.
Payable to ACME REVIVAL INC, write Check Point in memo line, and mail your check to: 191 University Blvd. Suite 340, Denver, CO 80206. Payment are collected every weekday excluding federal holidays.
