Acme Revival is an independent repair network that operates separately from the manufacturers whose devices we service. Our independence enables a repair model that exists beyond manufacturer-controlled strategies, while preserving the ability to work with manufacturers where appropriate.
Atlas Sound, L.P., operating under the AtlasIED brand, is a long-established manufacturer of professional commercial audio, communications, and life-safety systems. The company designs and manufactures loudspeakers, paging and public-address systems, emergency/mass-notification equipment, intercom products, amplifiers and DSP equipment, sound-masking systems, IP-networked audio devices, and electronic equipment racks/cabinets. Atlas is particularly known for installed commercial sound and communications equipment used in schools, airports and transportation facilities, corporate buildings, hospitality venues, healthcare environments, and other large facilities. Its heritage goes back to 1934 and the early commercial PA industry.
Speaker wiring can become shorted from damaged insulation, staples penetrating the cable, contact with metal conduit, or crossed conductors. This can trigger amplifier fault protection, excessive current draw, loss of audio, or eventual amplifier failure.
An incorrect impedance or load connected to an amplifier causes excessive current draw and can activate protection circuitry. Atlas specifically identifies incorrect loading as a common cause of amplifier failure, particularly in distributed 25V/70V systems.
A speaker accidentally configured for an 8-ohm connection or an incorrect wattage tap in a 70V system can severely overload the amplifier. Atlas documentation notes that this type of configuration error can cause amplifier failure after continued operation.
Connecting too many speakers or selecting taps whose combined wattage exceeds the amplifier's rated output overloads the amplifier. The system may initially operate at low volume but experience faults, distortion, overheating, or eventual failure under higher demand.
Loose terminals, crossed wiring, or deteriorated connections can cause complete loss of sound or audio that repeatedly cuts in and out. Connections throughout the signal and speaker path should be checked when intermittent operation occurs.
Moisture exposure can corrode speaker terminals or partially short connections, producing reduced output or unreliable audio. Atlas specifies weather-resistant terminal covers on applicable outdoor speakers to help prevent this condition.
Driving an amplifier or loudspeaker beyond its rated limits produces distortion at increased volume and can damage the equipment. Reducing amplifier output and verifying that speaker power limits are not exceeded are the documented corrective actions.
Excessive amplifier temperature can trigger the unit's fault or protection system and interrupt normal operation. Atlas amplifier fault-reporting systems specifically identify temperatures exceeding the channel's safe operating range as a hardware fault condition.
Loose grilles, mounting hardware, internal components, or physical speaker damage can produce buzzing, rattling, or abnormal sound. Atlas troubleshooting documentation recommends checking the grille and other hardware before inspecting the loudspeaker itself for damage.
Connect with a technician.
Orders can typically be cancelled 24 hours prior to shipping
Get a real-time offer. Enter the make and model to begin.
Acme offers several ways to pay your service or repair balance.
Securely powered by 
This service is provided by Community Federal Savings Bank (“CFSB”), member FDIC, for which GoCardless Ltd acts as a third-party servicer.
Payable to ACME REVIVAL INC, write Atlas Sound in memo line, and mail your check to: 191 University Blvd. Suite 340, Denver, CO 80206. Payment are collected every weekday excluding federal holidays.
